Against Backplate, Eliminating The Gap. See Figure - Pentair intellidrive pid10 Owner's Manual

Installation
Mounting the Drive
To mount the Drive as shown in Figure 6, follow
this procedure:
1. First, remove the cover by backing out screw
at bottom of front cover.
2. Push on backplate with thumbs while pulling
the cover toward you with index fingers,
creating a gap. See Figures 3 and 4.
Figure 3 - Separate cover and backplate
Figure 4 - Gap between cover and backplate
3. Pull bottom of cover towards you; lift up on
cover and remove. See Figure 5.
Figure 5 - Pull out bottom of cover
4. With the cover removed, permanently mount
the Drive using the top slotted hole, plus
either the three bottom holes (for flat surface
mounting) or the center bottom hole (for
attaching to a post or stud)
.
See Figure 6.
5. Ensure the Drive's ventilation holes are not
blocked and there is enough space around it
to allow free air flow (minimum 3" clearance
on top, bottom, and sides). See Figure 6. Once
the Drive is mounted, electrical wiring can be
connected.
Typical
230VAC
Circuit
Breaker
(Double
Width)
Figure 6 - Attaching Drive to wall
6. To reattach the Drive cover, hook the top of it
on backplate (be sure to leave a gap). Lower
bottom of cover into place. Push cover evenly
against backplate, eliminating the gap. See
Figure 7.
Figure 7 - Reattaching Drive cover
7. Replace screw at bottom of front cover.
7
5997 0412