Dodge Challenger SRT 2016 Owner's Manual page 93

8. If the child restraint has a top tether strap and the
seating position has a top tether anchorage, connect
the tether strap to the anchorage and tighten the tether
strap. See the section "Installing Child Restraints
Using the Top Tether Anchorage" for directions to
attach a tether anchor.
9. Test that the child restraint is installed tightly by
pulling back and forth on the child seat at the belt
path. It should not move more than 1 inch (25.4 mm)
in any direction.
Any seat belt system will loosen with time, so check the
belt occasionally, and pull it tight if necessary.
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 91
Installing Child Restraints Using The Top Tether
Anchorage
WARNING!
Do not attach a tether strap for a rear-facing car seat
to any location in front of the car seat, including the
seat frame or a tether anchorage. Only attach the
tether strap of a rear-facing car seat to the tether
anchorage that is approved for that seating position,
located behind the top of the vehicle seat. See the
section "Lower Anchors and Tethers for CHildren
(LATCH) Restraint System" for the location of ap-
proved tether anchorages in your vehicle.
2