Dodge Challenger SRT 2016 Owner's Manual page 292

290 UNDERSTANDING YOUR INSTRUMENT PANEL
away. This gives you the most reaction time. To change
the setting for more dynamic driving, select the Near
setting. This warns you of a possible collision when you
are much closer to the vehicle in front of you. To change
the FCW status, press and release the "Near" or "Far"
button. For further information, refer to "Adaptive
Cruise Control (ACC)" in "Understanding The Features
Of Your Vehicle".
• Paddle Shifters — If Equipped
When this feature is selected, the paddle shifters can be
enabled or disabled. Select the "Enable" or "Disable"
button on the touchscreen.
• ParkSense — If Equipped
The ParkSense system will scan for objects behind the
vehicle when the gear selector is in REVERSE and the
vehicle speed is less than 11 mph (18 km/h). It will
provide an alert (audible and/or visual) to indicate the
proximity to other objects. The system can be enabled
with Sound Only, or Sound and Display. To change the
ParkSense status, press and release the "Sound Only" or
"Sound and Display" button. Refer to "ParkSense" in
"Understanding The Features Of Your Vehicle" for sys-
tem function and operating information.
• Rear ParkSense Volume — If Equipped
The Rear ParkSense Chime Volume settings can be se-
lected from the DID or Uconnect System. The chime
volume settings include LOW, MEDIUM, and HIGH. The
factory default volume setting is MEDIUM. To make
your selection, press the "Rear ParkSense Vol." button on
the touchscreen, until a check-mark appears next to
setting, indicating that the setting had been selected.
ParkSense will retain its last known configuration state
through ignition cycles.
• Blind Spot Alert — If Equipped
When this feature is selected, the Blind Spot Alert feature
Provides alerts, visual and/or audible, to indicate objects