Installation Guide - Nortel 4500 Series Installation Manual

2
3
4
Copyright © 2007, Nortel Networks
.
Setting IP parameters for the Nortel Ethernet Routing Switch 4500 Series 39
You can use any terminal or PC with an appropriate terminal
emulator as the management
(page 39) lists the parameters that you must use with any terminal
emulation software used to connect to the switch.
Terminal emulation settings
Property
Baud Rate
Data Bits
Stop Bits
Parity
Flow Control
You require a console cable and connector to match the male DTE
connector (DB-9) on the switch to connect the terminal to the switch
console port.
Set the terminal protocol on the terminal or terminal emulation
program to VT100 and VT100/ANSI.
Connect to the switch using the terminal or terminal emulation
application.
When the switch configuration is set to factory default the following
screen appears. Enter the information requested at each prompt.
CLI Quickstart welcome screem
Welcome to the 4548GT-PWR setup utility. You
will be requested for information to initially
configure for the switch. When finished the
information will be applied and stored in
the switch NVRAM.
are configured, additional configuration can
proceed using other management interfaces.
Press ^C to abort at any time.
The in-band IP Address prompt line appears
Please provide the in-band IP Address[0.0.0.0]:
10.127.232.30
The in-band sub-net mask prompt line appears
Please provide the in-band sub-net mask[0.0.0.0]:
255.255.255.0
The Default Gateway prompt line appears
Please provide the Default Gateway[0.0.0.0]:10.1
27.232.1
Nortel Ethernet Routing Switch 4500 Series

Installation Guide

NN47205-300 02.01 Standard
5.0 23 February 2007
station." Terminal emulation settings"
Value
9600 bps
8
1
None
None
Once the basic parameters
Nortel Networks Confidential