Troubleshooting - Lorex LNR600 Series Instruction Manual

22

Troubleshooting

When a malfunction occurs, it may not be serious and can be corrected easily. The follow-
ing describes the most common problems and solutions. Please refer to the following be-
fore calling Lorex Technical Support:
Error
• System is not receiving
power, or is not powering up.
• Hard drive is not detected by
the system.
• Hard drive is full (0%) and
the unit is no longer
recording.
• There is no picture on moni-
tor/TV after connecting it to
the system.
#LX400078; r.36882/36882; en-US
Possible Causes
• Cable from power adapter is
loose or is unplugged.
• Power switch is set to OFF (
) position.
• Cables are connected, but
system is not receiving suffi-
cient power.
• Hard drive cables are loose
or not properly connected.
• There is no hard drive in the
system.
• Overwrite is not enabled.
• Monitor/TV not detected by
system.
• Input channel for system not
selected on monitor/TV.
• Video cable is loose or has
become disconnected.
Solutions
• Confirm that all cables are
connected correctly.
• Confirm that the power
adapter is securely con-
nected to the back of the unit.
• Confirm that the power switch
is in the ON (I) position.
• Confirm that the system is
powered on (LED indicators
on the front should be ON).
• If the unit is connected
through a power bar or surge
protector, try bypassing the
bar and connecting the
power directly to the wall
outlet.
• Confirm that there is power at
the outlet:
◦ Connect the power cable
to another outlet.
◦ Test the outlet with anoth-
er device (such as a lamp
or phone charger).
• Remove the housing and
check that hard drive cables
are firmly connected.
• Open the housing and install
compatible hard drive. Make
sure to format the drive after
installing. For details, see .
• From the Main Menu, select
>Setting>Gener-
al>General. Select Overwrite
under HDD Full and click OK.
• Power off the monitor/TV and
system. Power on the moni-
tor/TV, and then power on the
system.
• On the monitor/TV, select the
input channel the system is
connected to.
• Check the video cable con-
nection to the system and
monitor/TV.
151