Configuring Email Alerts - Lorex LNR600 Series Instruction Manual

14 Using the Main Menu
7. Click OK to save your settings.
NOTE
Please allow 10~15 minutes for the DDNS servers to update with your new DDNS address before at-
tempting to connect.

14.3.5 Configuring Email Alerts

You can configure the system to send out email alerts for motion detection or other events.
NOTE
To send out motion detection alerts, you must enable the Send Email option for motion detection on each
camera you would to receive alerts from. For details, see 14.3.8 Configuring Motion Detection, page 57.
To configure Email Alerts:
1. From the Main Menu, click
2. Check Enable to enable email notifications.
If you want to use Lorex's email server (recommended):
1. Under Mail Select, select Lorex Mail to use the Lorex email server to send out alarm
notifications. This is the recommended setting.
2. Configure the following:
• Email Schedule: Configure time periods during which email alerts will be sent.
• Receiver: Enter the email address that will receive alerts.
• Sender: Enter the sender's email address.
• Subject: Enter the subject line for the email alert.
• Attachment: Check to include a jpg image attachment of the camera.
NOTE
You must enable the Snapshot option for motion detection on each camera you would to receive
attachments. For details, see 14.3.8 Configuring Motion Detection, page 57.
• Interval: Enter the interval between alert emails.
• Health Enable: Check to enable health check emails. Health check emails will be
sent periodically to ensure that the system is functioning normally. If you enable
health check emails, enter the Interval in minutes.
3. Click Test to send a test email.
#LX400078; r.36882/36882; en-US
and then select Network>Email.
55