Configuring Alarm Input Devices - Lorex LNR600 Series Instruction Manual

14 Using the Main Menu
4. Configure the following to customize settings for video loss events:
• Period: Click Setup to configure a schedule when video tamper alarm will be acti-
vated. It is recommended to leave this on the default setting, so you will be alerted
any time one of your cameras is tampered with.
• Alarm Out: Select the alarm output devices (not included) that will trigger when vid-
eo tamper occurs.
• Latch: Enter the number of seconds an alarm output device will activate after video
tamper occurs.
• Show Message: Check to show a popup message on the monitor if one of your
cameras is tampered with.
• Send Email: Check to enable email alerts. You must configure email alerts before
you will be able to receive them (see 14.3.5 Configuring Email Alerts, page 55).
• Channels: Click the checkbox to enable video recording when video tamper occurs.
You can then select the channels the system will record when video tamper occurs
on the currently selected channel.
• PTZ Activation: Check to enable PTZ actions when video tamper occurs (PTZ
camera required; not included). Click Setup to select which PTZ actions will be tak-
en by each camera.
• Post_REC: Enter the number of seconds the system will record after video tamper
occurs.
• Sequence: Check to enable a custom sequence mode when motion is detected on
the selected channel. Then click the channels you would like to display in the cus-
tom sequence mode.
• Snapshot: Click the box to enable snapshot recording when video tamper occurs.
You can then select which channels will save snapshots when video tamper occurs
on the currently selected channel.
• Log Enable: Check to activate log.
• Buzzer: Check to enable the system buzzer when video tamper occurs on the cur-
rently selected channel.
5. Click OK to save changes.

14.3.11 Configuring Alarm Input Devices

You can connect alarm input devices such as motion sensors (not included) or glass break
detectors (not included) to the system. The system can be set to trigger recording or take
other actions when these devices are activated.
To configure alarm input devices (not included):
1. From the Main Menu, click
#LX400078; r.36882/36882; en-US
and then click Event>Local Alarm.
61