Configuring The Snapshot Schedule; Configuring Hard Drive Groups (Advanced) - Lorex LNR600 Series Instruction Manual

14 Using the Main Menu

14.3.18 Configuring the Snapshot Schedule

You can set a schedule for recording snapshots from the cameras.
To set up the snapshot schedule:
1. From the Main Menu, click
2. Under Channel, select the channel you would like to configure or select All.
3. Configure the schedule as needed:
• Check Continuous or Motion to select the recording type you would like to
configure.
• Click and drag on each day to customize the recording schedule. The schedule is
set up as a grid, which each block representing one hour.
• Click next to All to link the recording schedules for all days. The icon for a day
changes to when it is linked. You can also click the boxes next to individual
days to link them to each other. If the recording schedule is linked, changes made
to one of the days will apply to every day that is linked.
• Click to disable all recording of the selected type on the selected day.
• Click if you need to set a more precise schedule down to the minute.
4. Click OK to save changes.

14.3.19 Configuring Hard Drive Groups (Advanced)

Hard drive groups allow you to balance recordings across multiple hard drives. For exam-
ple, you can record channels 1~4 to one hard drive and 4~8 to a second hard drive. This
can reduce the amount of wear on the hard drives and may extend the life of the hard
drives.
NOTE
• Two hard drives must be installed in the system to use hard drive groups, and both hard drives must
be formatted as Read-write hard drives. For details on installing hard drives, see 20 LNR600 Series
Hard Drive Installation, page 145.
#LX400078; r.36882/36882; en-US
and then click Storage>Schedule>Snapshot.
66