Configuration Examples; Example For Setting Primary And Secondary Ip Addresses; Figure 1-1 Networking Diagram For Setting Ip Addresses - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - IP Service
Step 2 Run the display ip interface brief [ interface-type [ interface-number ] ] command to view brief
information about the IP address on the interface.
----End

1.5 Configuration Examples

This section provides several examples of IP address configuration.

1.5.1 Example for Setting Primary and Secondary IP Addresses

1.5.2 Example for Configuring a Tunnel Interface to Borrow the IP Address of a Loopback
Interface
1.5.1 Example for Setting Primary and Secondary IP Addresses
Networking Requirements
As shown in
to two different network segments, that is 172.16.1.0/24 and 172.16.2.0/24. It is required that
the S9300 can access the two network segments but the host in 172.16.1.0/24 cannot interconnect
with the host in 172.16.2.0/24.

Figure 1-1 Networking diagram for setting IP addresses

Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
Issue 02 (2009-08-06)
Figure 1-1, GE 1/0/1 of the S9300 is connected to a LAN, in which hosts belong
172.16.1.0/24
172.16.2.0/24
Analyze the address of the network segment to which each interface is connected.
Set the secondary IP addresses for an interface.
NOTE
Note that the primary and secondary IP addresses of the same interface or different secondary IP addresses
of the same interface cannot be in the same network segment.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 IP Address Configuration
S9300
GE 1/0/1
VLANIF 100
172.16.1.1/24
172.16.2.1/24 sub
1-7