Configuring A Dhcp Server Group - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - IP Service
through the DHCP relay agent. To ensure that the clients can obtain IP addresses, the server
must be the DHCP server based on the global address pool. That is, the interface connecting the
DHCP server and the DHCP relay agent must not be configured with any interface address pool.
Pre-configuration Tasks
Before configuring the DHCP relay agent, complete the following tasks:
l
l
Data Preparation
To configure the DHCP relay agent, you need the following data.
No.
1
2
3

2.3.2 Configuring a DHCP Server Group

Context
Do as follows on the S9300.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
dhcp server group
A DHCP server group is created and the DHCP server group view is displayed.
You can configure up to 512 DHCP server groups.
Step 3 Run:
dhcp-server
DHCP servers are added to a DHCP server group.
You can add up to 20 DHCP servers to a DHCP server group.
----End
Issue 02 (2009-08-06)
Configuring a DHCP server
Configuring a reachable route between the S9300 and the DHCP server
Data
Name of the DHCP server group
IP address of the DHCP server in the DHCP server group
Number and IP address of the interface enabled with DHCP relay
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 DHCP Configuration
2-3