Peripheral Information And Electrical Specifications; Parameter Information - Texas Instruments OMAP-L137 User Manual

OMAP-L137
SPRS563G – SEPTEMBER 2008 – REVISED JUNE 2014

6 Peripheral Information and Electrical Specifications

6.1

Parameter Information

6.1.1 Parameter Information Device-Specific Information
42 Ω
4.0 pF 1.85 pF
A. The data sheet provides timing at the device pin. For output timing analysis, the tester pin electronics and its
transmission line effects must be taken into account. A transmission line with a delay of 2 ns or longer can be used to
produce the desired transmission line effect. The transmission line is intended as a load only. It is not necessary to
add or subtract the transmission line delay (2 ns or longer) from the data sheet timings.
Input requirements in this data sheet are tested with an input slew rate of < 4 Volts per nanosecond (4 V/ns) at the
device pin and the input signals are driven between 0V and the appropriate IO supply rail for the signal.
The load capacitance value stated is only for characterization and measurement of AC timing signals. This
load capacitance value does not indicate the maximum load the device is capable of driving.
6.1.1.1 Signal Transition Levels
All input and output timing parameters are referenced to V
V = 1.65 V. For 1.8 V I/O, V
ref
Figure 6-2. Input and Output Voltage Reference Levels for AC Timing Measurements
All rise and fall transition timing parameters are referenced to V
V MAX and V MIN for output clocks.
OL OH
Figure 6-3. Rise and Fall Transition Time Voltage Reference Levels
56 Peripheral Information and Electrical Specifications
Tester Pin Electronics
3.5 nH
Transmission Line
Z0 = 50 Ω
(see note)
Figure 6-1. Test Load Circuit for AC Timing Measurements
= 0.9 V. For 1.2 V I/O, V
ref
Submit Documentation Feedback
Product Folder Links:
Data Sheet Timing Reference Point
Output
Under
Test
Device Pin
(see note)
for both "0" and "1" logic levels. For 3.3 V I/O,
ref
= 0.6 V.
ref
V
ref
MAX and V
IL
V = V MIN (or V
ref IH
V = V MAX (or V
ref IL
Copyright © 2008–2014, Texas Instruments Incorporated
OMAP-L137
www.ti.com
MIN for input clocks,
IH
MIN)
OH
MAX)
OL