Windows 7 Settings - Teledyne CombiFlash Rf User Manual

This guide provides instructions for Windows 7 (7.2.1),
Windows Vista (7.2.2), Windows XP (7.2.3), and Windows 2000
(section 7.2.4). Refer to the applicable section, then follow the
instructions in section 7.2.5 to complete the direct connection.
Note
A direct connection requires a "crossover" CAT5 cable. Standard
CAT5 network cables will not work. You can purchase a crossover
cable locally or ask your Information Technology department to
assemble one. You can also order a crossover cable (part number
480-6545-02) from Teledyne Isco.
Note
These instructions assume that the system is using the factory-set
IP address of 192.168.1.51.
Note
The following instructions may require a user account with
Administrator privileges on the PC. If you cannot modify the
settings in sections 7.2.1 through 7.2.4, contact your Information
Technology department.

7.2.1 Windows 7 Settings

1. From the Windows Start menu, select Control Panel, then
select the Network and Sharing Center option. The PC
displays the Network and Sharing Center.
2. Select the Change Adapter Settings option to display the
available network connections.
3. Right-click on the Local Area Connection icon and select
the Properties option.
4. Select Internet Protocol Version 4 (TCP/IPv4) and click the
Properties button. The PC displays the Internet Protocol
Version 4 (TCP/IPv4) Properties window (Figure 7-2).
Note
If the Internet Protocol Version 4 (TCP/IPv4) option is not listed,
click the Install button to add it. If assistance is needed, press the
F1 keyboard button to display Windows Help.
Section 7 Remote Interfaces
7-5