Windows 2000 Settings - Teledyne Installation Guide Installation Manual

Note
The following instructions may require a user account with
Administrator privileges on the PC. If you cannot modify the
settings in sections 4.2.1 through 4.2.3, contact your Information
Technology department.

4.2.1 Windows 2000 Settings

1. From the Windows Start button, select "Settings>Control
Panel" to view the control panels.
2. Locate the "Network and Dial-up Connections" icon and
open this control panel.
3. Highlight the "Local Area Connection" icon. View the
properties by right-clicking and selecting "Properties." The
Local Area Connection Properties Window will open
(Figure 4-1).
4. Highlight the "Internet Protocol (TCP/IP)" item in the list,
and click on the "Properties" button. The Internet Protocol
Properties Window will open (Figure 4-2).
Note
The following steps change the local area connection settings. If
the PC must be restored to its original network configuration,
record the present Internet Protocol (TCP/IP) settings now.
5. Click the "Use the following IP address" option.
6. Enter the IP address "192.168.1.200".
7. Enter the default Subnet Mask "255.255.255.0."
8. Click the OK button to close the Internet Protocol
properties window. Then, click the OK button to close the
Local Area Connection properties window.
9. Shut down the PC and place the CombiFlash R
Standby.
Section 4 Remote Interfaces
system in
f
4-5