After A Speaker Call (Announcement) In A Group; Trunk Flash - Siemens HiPath 2000 Operating Instructions Manual

Step by Step
Consultation
Consultation
After a Speaker Call (Announcement) in a
Group
If this function has been configured (contact the service
personnel), you can use a speaker call (announcement,
! Page 25) to announce a call in progress to a group of
users ! Page 52.
After a member of the group has accepted the call re-
quest, you can transfer the waiting party.
Precondition: You are conducting a call.
Press the key. LED flashes. Enter the code.
qld
o w
Enter the group's station number.
s
Announce the call.
When a member of the group accepts the call, you are
connected to this party.
t
Replace the handset.

Trunk Flash

To activate ISDN-type services and features through the
network carrier's analog trunks or those of other com-
munications platforms (such as "consultation hold"), you
must send a signal to the trunks before dialing the ser-
vice code or telephone number.
Precondition: You have set up an external connection
via an analog line.
Press the key. LED flashes. Enter the code.
qie
o
Enter the service code and/or telephone number.
Making Calls – Convenience Functions
If the connection between the two other parties
is not established within 45 seconds, the call
from the first party returns to you (recall).
33