Panasonic KX-FM255 Operating Instructions Manual page 103

Multi-Function Center
Problem
The facsimile unit cannot print
documents from your PC.
The facsimile unit cannot print the
documents received on your PC.
Documents are received by the
facsimile unit but I want to receive
them on the PC.
Documents are received on the PC
but I want to receive them on the
facsimile unit.
I want to print a received fax with the
pre-selected printer.
I want a received fax to be printed by
another printer.
Documents cannot be scanned on
the PC.
Documents cannot be sent by the
PC.
¡"Panasonic MFC Print" was not selected as your printer. Select it.
¡The print manager of Windows 3.1 was not used. Test using
Notepad in Windows 3.1 or Wordpad in Windows 95.
¡Another device is in use. Check the outbox, then wait until the
other device is finished or cancel it.
¡The com port was set improperly. Check the properties and set the
com port with "Test" again.
¡The com port is competing with the mouse or network card, or uses
the same IRQ as MFC-Print. Change the IRQ setting (refer to your
Windows user manual).
¡The performance of your PC is not sufficient. At least, CPU386 (DX
33MHz) and 4M RAM are necessary.
¡An OS (Macintosh, DOS, Win NT, etc.) which the Multi-Function
Center does not support was used. Use Windows 95 or
Windows 3.1/3.11.
¡All com ports are in use. Assign a com port for the Multi-Function
Center.
¡The Inbox was set to pause. Remove the check mark from the
Pause Inbox in the Message Center window.
¡The PC link feature (#14) of the facsimile unit is set to OFF. Set to
ON (see page 93).
¡The Message Center is not running. Open it.
¡The Inbox was not set to pause. Set the Inbox to pause or close
the Message Center.
¡The Message Center is running. Remove the check mark on the
Load in Message Center with Windows property.
¡Select Automatically Print Incoming Faxes in the Receive dialog
box of the Inbox properties.
¡Set the desired printer as default in the Print Settings box, or select
the desired printer in the Print dialog box.
¡See the Viewer instructions in the operating instructions or help list.
¡There is not enough hard disk capacity. Delete unnecessary
applications or data.
¡The MFC scan program was activated when other applications
were running and the swap file was full. Check the swap file size
and extend the swap file.
¡The MFC scan program was activated and there is not enough
RAM capacity. Close the applications in progress.
¡Try cold reboot.
¡The receiving unit is busy. Check the outbox and error status log.
¡The MFC is installed incorrectly. Install it again.
¡There is not enough RAM capacity. Try again after closing other
applications.
¡A different fax software was used instead of the Multi-Function
Center.
For Assistance, Call 1-800-435-7329
Operations
Cause & Remedy
103