Xerox DocuMate 3125 User Manual page 40

Maintenance
5. Remove the roller from the scanner and discard it, it cannot be repaired.
6. Before installing the new roller, clean any dust that may have gotten on it during shipping.
7. Insert the left end of the new roller assembly into the hole in the roller channel. Angle the
roller module up and into the roller channel. Align the tab on the lock flange with the slot in
the scanner.
Hold the feed roller module fully in the scanner door while you lock it in place.
8. Use the lever to rotate the locking tab into the slot in the scanner. Push on the lever until it
clicks in place and locks the roller in the scanner.
The lock will "click" into place when it is secure. However, if it does not rotate easily into the
housing, make sure the flange is properly seated in its latch.
User Guide
® ®
Xerox DocuMate 3125 Scanner
31