Table of Contents
Advertisement
The remote control information
n Batteries
• Insert so the poles (+ and –)
match those in the remote
control.
• Do not use rechargeable type
batteries.
• Do not mix old and new
batteries.
• Do not use different types at
the same time.
• Do not heat or expose to flame.
• Do not take apart or short circuit.
• Do not attempt to recharge alkaline or manganese batteries.
• Do not use batteries if the covering has been peeled off.
Mishandling of batteries can cause electrolyte leakage which can
damage items the fluid contacts and may cause a fire.
Remove batteries if the remote control is not going to be used for a
long period of time. Store in a cool, dark place.
Disc and card handling
n How to hold a disc or card
Do not touch the recorded
surface or the terminal surface.
n Concerning non-cartridge discs
Be careful about scratches and dirt.
n If there is dirt or condensation on the disc
Wipe with a damp cloth and then wipe dry.
n Handling precautions
• Do not attach labels or stickers to discs. (This may cause disc
warping and un-balanced rotation, rendering it unusable.)
• Write on the label side of the disc only with a soft, oil-based felt
pen. Do not use ballpoint pens or other hard writing implements.
• Do not use record cleaning sprays, benzine, thinner, static
electricity prevention liquids or any other solvent.
The manufacturer accepts no responsibility and offers no compensation for loss of recorded or edited material due to a problem with
the unit or recordable media, and accepts no responsibility and offers no compensation for any subsequent damage caused by such
loss.
Examples of causes of such losses are
• A disc recorded and edited with this unit is played in a DVD recorder or computer disc drive manufactured by another company.
• A disc used as described above and then played again in this unit.
• A disc recorded and edited with a DVD recorder or computer disc drive manufactured by another company is played in this unit.
Inserting/Removing SD card
When the card indicator ("SD") on the unit's display is flashing, the card is being read from or written to. Do not turn off the unit or remove the card.
Such action may result in malfunction or loss of the card's contents.
• Inserting foreign objects can cause a malfunction.
• You can use SD Memory Cards with capacities from 8 MB to 2 GB (Ô page 5).
Opening the cover
Press the protruding
part to open the cover.
Insert the card label up with the cut-off corner on the right.
(Do not forget to close the cover. Ô right)
Automatic drive select function
If you insert an SD card while the unit is stopped, the "SD Card Operations" screen is displayed. Press [e,r] to select an item and press [ENTER]
to switch to the SD drive (Ô page 26, 36).
If you remove an SD card, the DVD drive is automatically selected.
RQT8327
Keep the small memory cards such as the SD Memory Card out of reach of children. If swallowed, seek
6
medical advice immediately.
R6/LR6, AA
Inserting the card
Press on the center of
If you are using a
the card until it clicks
miniSD™ card, insert
into place.
it into the miniSD™
card adaptor that
comes with the card.
Insert and remove this
adaptor from the unit.
n Use
Remote control signal sensor
20
20
30
30
7 m (23 feet) directly in front of the unit
• Do not use scratch-proof protectors or covers.
• Do not expose the terminals of the card to water, garbage or other
strange things.
• Do not drop, stack, or impact discs. Do not place objects on them.
• Do not use the following discs:
– Discs with exposed adhesive from removed stickers or labels
(rented discs, etc.).
– Discs that are badly warped or cracked.
– Irregularly shaped discs, such as
heart shapes.
• Do not place in the following areas:
– In direct sunlight.
– In very dusty or humid areas.
– Near a heater.
– Locations susceptible to significant differences in temperature
(condensation can occur).
– Where static electricity or electromagnetic waves occur.
• To protect discs from scratches and dirt, return them to their cases
or cartridges when you are not using them.
Removing the card
1 Press on the center
of the card.
2 Pull it straight out.
ADAPTER
Closing the cover
Hide quick links:
Advertisement
Table of Contents
