Table of Contents
Advertisement
Cable Power Button
-
The CABLE
Power
button on the Remote Control has been designed to
operate selected brands of Cable Converter Boxes. The
proper Cable Converter Box infra-red code must be
obtained prior to use. (Please refer to Programming the
Universal Remote for programming instructions.) The
TVNCR/CABLE
switch should be in the cable position.
NOTE: Use the Channel UP and DOWN buttons on the
Remote for selecting Cable
Converter
Box
Channels.
PIP Swap Button
-
Press the SWAP button
(when the PIP frame is displayed) to interchange what is
being viewed on the Main Picture with that of the PIP
frame.
Located On Remote Control
CABLE
POWER
Use to select Cable Box
Channelsafterprogramming
Infra-redCode.
CH 021
VIDEO 1
PIP VIDEO 1
PIP CH 02
• Audio will be that of the Main Picture.
PIP Size Button
- Press the SIZE button (when
the PIP frame is displayed) to choose either the large or
small PIP frame.
PIP (Picture in Picture) Button-
This
feature allows monitoring one channel while watching
another when a second video source with a tuner is
connected (such as a VCR) to the television.
• The TV/VCR/CABLE
Switch should be in the TV
position (LEFT) before operating PIP buttons.
• S-Video connection will also operate the PIP feature
(refer to OPTIONAL S-VIDEO VHS CONNECTION
section).
• When the Main Picture is in Video mode with no
signal, the PIP will not operate properly.
PIP Operation
1.
Turn VCR ON and select a desired channel.
2.
Press the PIP button (television must be ON). The
PIP frame will appear at the position it was last dis-
played. The Main Picture Video Source and PIP Vid-
eo Source will display on screen momentarily. Audio
will be that of Main Picture.
3.
Press the PIP button again to cancel PICTURE IN
PICTURE feature (if desired).
NOTE: For PIP Video source connection, refer to PIP
External
Video
and Antenna
Connections
section.
/
Large PIP Frame
SmallPIPFrame
--14-
Advertisement
Table of Contents
