Table of Contents
Advertisement
Installation
Receiver Location
Locate for comfortable viewing. Avoid placing where sunlight or other bright light (including reflections) will fall on the
screen.
Use of some types of fluorescent lighting can reduce remote control transmitter range.
Adequate ventilation is essential to prevent internal component failure. Keep away from areas of excessive heat or
moisture.
To insure optimum color purity do not position magnetic equipment (motors, fan, other speakers, etc.) nearby.
Optional
External Equipment
Connections
The Video/Audio connections between components can be made with shielded video and audio cables. For best perfor-
mance, video cables should utilize 75 ohm coaxial shielded wire. Cables are available from your dealer or electronic
supply house.
Before you purchase any cables, be sure you know what type of output and input connectors your various components
require. Also determine the length of cable you'll need.
AC Power Supply Cord
CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE
SLOT OF AC OUTLET AND FULLY INSERT. DO NOT USE THIS (POLARIZED) PLUG
WITH A RECEPTACLE OR OTHER OUTLET UNLESS THE BLADE CAN BE FULLY
INSERTED TO PREVENT BLADE EXPOSURE.
Polarized Plug
Remote Control Battery Installation
& Replacement
Battery Installation
Batteries: Use two "AA" batteries.
1. Turn the Transmitter face down. To remove bottom cover, press down
on marking and slide cover off in the direction indicated.
2.
Install the batteries as shown in the battery compartment.
(Polarity (+)
or (-) must be correct.)
3.
Replace the cover and slide in reverse until the lock snaps.
Precaution
on Battery Use
Incorrect installation can cause battery leakage and corrosion that will
damage the Remote Control Transmitter.
Observe the Following Precautions:
1.
Batteries must be replaced as a pair.
2.
Do not combine a used battery with a new one.
3.
Do not mix battery types (Example: "Zinc Carbon" with "Alkaline").
4.
Do not attempt to charge, short-circuit, disassemble, heat or burn used
batteries.
5.
Battery replacement is necessary when Remote Control reacts
sporadically or stops operating the Receiver.
IIII II
®
_J
4.,I
4.1
®
®
{u
4,,I
®
Press Down Here And
Slide Cover Back
ooooooooo
ooooooo
ooooo
ooo
J
-5-
Advertisement
Table of Contents
