Table of Contents
Advertisement
Functions
9.1
General information
You can operate the SITRANS TH300 either via the SIMATIC PDM parameterization
software or via the HART communicator. You can operate the SITRANS TH200 via the
SIPROM T parameterization software.
The following functions are available to you when operating the SITRANS TH300/TH200:
● identification
● Device data; this information is read-only
● Information about the measuring procedure
● Information on measurement interface
● Information about the output signal
● Certificates and approvals
SITRANS TH200/TH300
Operating Instructions, 06/2010, A5E00393069-03
– Information on operational reliability: day, description, message, assembly number
– Manufacturer and product name
– Order number, device serial number
– Revision numbers for firmware and hardware revision
– Sensor class and sensor type, e.g. Pt100 resistance thermometer or thermocouple
type B
– Sensor factor
– Sensor characteristic curve, e.g. linear temperature
– Measuring range and measuring unit
– Interface type: standard, differential or averaging circuit
– Connection type/sensor connection: two-wire, three-wire or four-wire input with
resistance-type transmitters
– Resistors for line compensation
– Offset to the measurement signal
– Additional information for the cold junction in thermocouples: internal, external or fixed
– Enable/disable of wire break or short circuit test
– Filter time constant for noise suppression attenuation
– Output limit values: alarm and saturation limits
– The following information is read-only: information on whether the transmitter is
allowed to be operated in intrinsically safe mode or not. This function can only be
performed using the SIMATIC PDM parameterization software or with the HART
communicator.
9
45
Advertisement
Table of Contents
