Table of Contents
Advertisement
Functions
9.16 Factory parameters
The following pair of values must be transferred to the parameter assignment software for
the characteristic curve correction of the pair of values i = 3: X[3] = 20 % and Y[3] = 20 %.
9.16
Factory parameters
Using the menu command Device ➜ Factory trim ➜ Reset factory settings, the configuration
of the transmitter is reset to its default values.
Note
Factory reset
The menu command Device ➜ Factory trim ➜ Reset factory settings always resets the
This factory reset has the same effect for "devices supplied ex stock" or "devices set
Furthermore, resetting the transmitter to its default values also resets a customer-specific
Once a factory reset has been performed, the transmitter has the following configuration:
Parameter
DAY
Description
Message
Serial number
Installation date (electronics)
Sensor class
Sensor type
Interface
Sensor connection
Sensor factor
Sensor offset 1
Start of scale value
Full scale value
Unit
Break monitoring
Short circuit monitoring
Short circuit limit
Lower end point analog output
Upper end point analog output
Alarm value
Linearization type
Attenuation
Runtime meters PV
58
parameters of the transmitter to the default values in the table listed below.
customer-specifically".
digital-to-analog converter trim and sensor calibration (one point trim or two point trim).
Reset to value
Is not reset
Is not reset
Is not reset
Is not reset
Is not reset
Resistance thermometer
Pt100 DIN IEC 751
Standard connection
Three-wire input
1.00
0.00 °C
0 °C
100 °C
°C
ON
ON
10 Ω
Is not reset
Is not reset
Is not reset
Linear to temperature
0.00 s
Are all reset to 0 h
Operating Instructions, 06/2010, A5E00393069-03
SITRANS TH200/TH300
Advertisement
Table of Contents
