Check For Error Messages - Agilent Technologies E4438C ESG Installation Manual

Operation Verification

Check for Error Messages

Check for Error Messages

1. Check the display to see if the ERR annunciator is turned on.
2. If the ERR annunciator is turned on, review the error messages in the queue by pressing
. The first error message in the queue will be shown in the text area of the display.
Error Info
Refer to the "Error Messages" on the Documentation
error messages. Refer to
Started."
If there is more than one error message (each message will be designated as 1 of n), press the
View Next Error Message
3. When you have resolved all of the error messages, press
4. Cycle the power on the signal generator and then restart this procedure until the signal generator powers
on without displaying the ERR annunciator.
26
Table 2-2, "Available ESG Documentation," on page 17
softkey until you have seen all of the messages.
for further information about specific
CD-ROM
Clear Error Queue(s)
>
Utility
in Chapter 2, "Getting
to delete the messages.
Chapter 3