Registering A Handset To A Base Unit - Panasonic KX-TG8301NZ Operating Instructions Manual

Panasonic digital cordless phone operating instructions
Table of Contents

Advertisement

used. If a handset moves out of range of
its base unit when "Auto" is selected on
base unit (page 29), it looks for another
base unit to make or receive calls. A
base unit and the handsets it
communicates with is called a "radio
cell".
Note:
L Calls are disconnected when the
handset moves from one radio cell to
another.
Registering a handset to a
base unit
The supplied handset and base unit are
pre-registered. If for some reason the
handset is not registered to the base unit
(for example, w flashes even when the
handset is near the base unit), register
the handset.
1
Handset:
K (centre of joystick) i N i
M
{V}/{^}: "Registration" i M
2
2 times
{V}/{^}: Select a base unit number.
3
i M
L This number is used by the
handset as a reference only.
4
Base unit:
Press and hold {x} for about 5
seconds. (No registration tone)
L If all registered handsets start
ringing, press the same button to
stop. Then repeat this step.
L The next step should be
completed within 90 seconds.
5
Handset:
Wait until "Enter Base PIN" is
displayed. i Enter the base unit
PIN (default: "0000"). i M
L If you forget your PIN, contact
your nearest Panasonic service
centre.
L When the handset has been
registered successfully, w stops
flashing.
Note:
L When you purchase an additional
handset, refer to the additional
handset's installation manual for
registration.
Selecting a base unit
When "Auto" is selected, the handset
automatically uses any available base
unit it is registered to. When a specific
base unit is selected, the handset makes
and receives calls using that base unit
only. If the handset is out of range of that
base unit, no calls can be made.
K (centre of joystick) i N i
1
M
{V}/{^}: "Select Base" i M
2
{V}/{^}: Select the desired base
3
unit number, or "Auto". i M
L The handset starts searching for
the base unit.
Deregistering a handset
A handset can cancel its own
registration (or the registration of
another handset) that is stored in the
base unit. This allows the handset to end
its wireless connection with the system.
K (centre of joystick) i ! i
1
M
{3}{3}{5}
2
{V}/{^}: "Deregistration" i
3
M
Programming
29

Advertisement

Table of Contents
loading

Table of Contents