Table of Contents
Advertisement
Error messages
If the unit detects a problem, one of the following messages is shown on the display.
Display message
Check Tel Line
Failed
Incomplete
Memory Full
No link to base.
Reconnect AC
adaptor.
Use rechargeable
battery.
You must first
subscribe to
Caller ID.
Cause/solution
L The supplied telephone line cord has not been
connected yet or not connected properly. Check the
connections (page 11).
L Phonebook copy failed (page 21). Confirm the other
handset (the receiver) is in standby mode and try
again.
L The receiver's phonebook memory is full. Erase the
unnecessary phonebook entries from the other
handset (the receiver) and try again.
L The phonebook memory is full. Erase unnecessary
entries (page 20).
L The bar call list memory is full. Erase unnecessary
entries (page 28).
L The maximum number of base units (4) is already
registered to the handset. Cancel unused base unit
registrations from the handset (page 30).
L The handset has lost communication with the base
unit. Move closer to the base unit and try again.
L Unplug the base unit's AC adaptor to reset the unit.
Reconnect the adaptor and try again.
L The handset's registration may have been cancelled.
Re-register the handset (page 29).
L A wrong type of batteries such as Alkaline or
Manganese was inserted. Use only the rechargeable
Ni-MH batteries noted on page 3, 12.
L You must subscribe to a Caller ID service. Once you
receive caller information after subscribing to a Caller
ID service, this message will not be displayed.
Useful Information
39
Advertisement
Table of Contents
