Lighted Handset Keypad; Backlit Lcd Display - Panasonic KX-TG2352PW Operating Instructions Manual

To put a call on hold
Press
(HOLD/INTERCOM/CLEAR)
•The IN USE/HOLD indicator light flashes, "Hold" is
displayed and the call is put on hold.
•To transfer the call to another handset, see page 40.
•If a call is kept holding for 6 minutes, an alarm tone will start to sound. After 4
additional minutes on hold the call will be disconnected.
•When you put on hold the call, "Line on hold" is shown on the display of other
handsets.
To release the hold
Press or
•Another handset user can also release the hold by pressing
•If another phone is connected on the same line (p. 52), you can also release the
hold by lifting its handset.
To adjust the receiver volume (HIGH, MEDIUM or LOW) or
speaker volume (6 levels) while talking
To increase, press
To decrease, press
•Each time you press Ö or Ñ, the volume level will
change.
•The number of steps indicates the volume level.
•The display will return to the length of the call.

Lighted handset keypad

The handset dialing buttons will light when you press a button, lift the
handset off the base unit or the charger, or when a call is received.
The lights will go out a few seconds after pressing a button, lifting the
handset, answering a call, hanging up a call, leaving the programming
mode or ending the intercom.

Backlit LCD display

The lighted handset display will stay on for a few seconds after pressing a
handset button, lifting the handset off the base unit or the charger,
hanging up a call, leaving the programming mode or ending the intercom.
For assistance, please call: 1-800-211-PANA(7262)
twice
.
.
Ñ
.
Ö
.
Hold
Ex. Receiver volume: High
Loud
Low
GF
[1]
or .
Speaker volume: Level 6
High
23