Recording From Radio Broadcasts - Panasonic SC-AK17 Operating Instructions Manual

5
1
2
3
5
A
22
RQT4708

Recording from radio broadcasts

Press [c DECK 2 OPEN] and insert the tape.
1
Close the holder by hand.
Tape direction is automatically set to " 3 3 3 3 3 ".
2
Except for SC-AK17 model and SC-AK27 Australia and
New Zealand model
Press [DOLBY NR].
1
You have to turn Dolby NR ON/OFF according to the type of
recording you want to make.
Every time you press the button: p NR W (OFF)
3
Press [REV MODE] to select the reverse mode.
3
2
Every time you press the button:
Tape direction
,
Select a radio station. Perform steps 1 through 3
4
on page 13.
Press [a REC/STOP] to start recording.
If you selected " ,
change to "
To stop recording
Press [a REC/STOP] again.
Recording can also be stopped by pressing [L].
To start recording on the reverse side
Load a tape and change the tape direction as following.
1. Press [TAPE DECK 1/2] and select tape deck 2.
2. Press [/] and immediately thereafter [L]. The tape direction will
be shown as "4".
To record from a specific point on a tape
Before recording, advance the tape to the point from where you want
to start recording.
To cut an unnecessary part while recording
1. Press [a REC/STOP] during the unnecessary part. The cassette
deck will go into the stop mode.
2. Press [a REC/STOP] to resume recording again. Recording will
continue in the same direction as before.
Note
When recording an AM broadcast, sound is momentarily interrupted
when you start and stop the recording.
To reduce noise while AM recording (Beat proof
function) A
Press [FM MODE/BP] while recording.
Each time you press the button, "BP1" and "BP2" will be displayed
alternately.
Select the position where there is less noise.
: One side is recorded, then recording stops auto-
matically.
: Both sides (front side reverse side) are recorded,
then recording stops automatically.
" in step 3, the direction will automatically
" when recording starts.