Recording From Radio Broadcasts - Panasonic SC-AK44 Operating Instructions Manual

2
1
2
SC-AK44
only
4
A
22
RQT5621
4
1
SC-AK44
SC-AK33 SC-AK22 SC-AK12
SC-AK44
SC-AK33 SC-AK22 SC-AK12

Recording from radio broadcasts

Wind up the leader tape so recording can begin immediately.
Press [c DECK 2 OPEN] and insert the tape.
Close the holder by hand.
SC-AK44 only
Press [REV MODE] to select the reverse mode.
Every time you press the button:
: One side, only, records.
: Both sides record (front side ¡ reverse side).
,
automatically changes to "
" "
is pressed.
Select a radio station. Perform steps 1 through 3
on page 12.
Press [a REC/STOP] to start recording.
FLAT To stop recording
Press [a REC/STOP] again.
Recording can also be stopped by pressing [L].
To record from a specific point on a tape
Before recording, advance the tape to the point from where you want
to start recording.
To cut an unnecessary part while recording
1. Press [a REC/STOP] during the unnecessary part. The cassette
deck will go into the stop mode.
2. Press [a REC/STOP] to resume recording again. Recording will
continue in the same direction as before.
MHz
SC-AK44
To start recording on the reverse side
Load a tape and change the tape direction as follows:
1. Press [TAPE, DECK 1/2] and select tape deck 2.
// J
2. Press [ ] and immediately thereafter [L]. The tape direction
FLAT
will be shown as "4".
MHz
SC-AK22
SC-AK33
To record on the other side of the tape
Turn the tape over and press [a REC/STOP].
Note
When recording an AM broadcast, sound is momentarily interrupted
when you start and stop the recording.
To reduce noise while AM recording (Beat proof
A
function)
Press [g/(, FM MODE/BP] while recording.
Each time you press the button, "BP1" and "BP2" will be displayed
alternately.
Select the position where there is less noise.
a
" when [ REC/STOP]
SC-AK12