Table of Contents
Advertisement
18
2
REVERSE MODE
Recording from Radio Broadcasts
PM MODE/BP
@ You can use normal and chrome tapes.
@ Check that the tape's tabs (see page 25) are intact.
@ The leader tape must be wound up before-hand. (See page 17)
IT
A EJECT
ADA
Press
REVERSE
MODE
to
select the reverse mode.
=
=: One side will record, and then
the tape will stop automatically
at the tape end.
>:
Both sides will record (forward
side -+ reverse side), and then
the tape will stop automaticalty
at the tape end.
¢z>: Same
as above.
(When you
press REC PAUSE, "¢=>"
will
be automatically switched over
to" 29")
Press
4 EJECT
on deck 2,
and then Insert the tape.
Close the holder.
REC PAUSE
Press REC PAUSE to put the
3
Ee
|
cassette deck into the re-
cording standby mode.
"TREC |" will light.
Press FM or AM to select the
band.
emu]
Press
TUNING
MODE
to
select "PRESET".
You can also tune in using "MANUAL"
mode.
TUNING MODE
4
GD
Press
V or A to select the
preset channel.
Press
<4 or > to start re-
cording.
b>: When
recording on either the
forward side or both sides.
"4: When recording only the reverse
side.
To stop recording:
Press D.
To cut an unnecessary part while recording:
1. Press REC PAUSE.
The cassette deck will go into the recording standby state.
2. To resume recording, press <4 or
corresponding to the direction
in which recording is taking place.
:
To reduce the noise while AM recording
(Beat proof function)
While in the recording standby mode of AM band;
Press FM MODE/BP.
Each time you press the button, BP 1 and BP 2 will be displayed
alternately.
Select the position where there is less noise.
Advertisement
Table of Contents
