Recording From Compact Discs - Panasonic SC-AK17 Operating Instructions Manual

4
7
1
2
3
4
6
1
2
7

Recording from compact discs

6
Press [c DECK 2 OPEN], and insert the tape.
1
Close the holder by hand.
Tape direction is automatically set to " 3".
2
Except for SC-AK17 model and SC-AK27 Australia and
New Zealand model
Press [DOLBY NR].
You have to turn Dolby NR ON/OFF according to the type of
1
recording you want to make.
Every time you press the button: p NR W (OFF)
3
Press [REV MODE] to select the reverse mode.
3
Every time you press the button:
2
,
Tape direction
Press [CD].
4
Insert CD in the tray.
5
(See page 14).
Press [DISC 1] – [DISC 5] to select the disc you
6
want.
Pressing [L] will stop playback.
Press [a REC/STOP] to start recording.
•
If you selected " ,
automatically change to "
•
The recording will proceed from the first track on the selected
CD and will continue on through the last track of the final disc
(page 15).
•
The tape deck stops automatically when the CD is finished.
To stop recording
•
To add a 4 second silent interval before stopping
Press [L]. The CD will stop automatically too.
•
To stop recording without a silent interval
Press [a REC/STOP]. The CD will stop automatically too.
To start recording on the reverse side
Load a tape and change the tape direction as following.
1. Press [TAPE DECK 1/2] and select tape deck 2.
2. Press [/] and immediately thereafter [L]. The tape direction will
be shown as "4".
To record from a specific point on a tape
Before recording, advance the tape to the point from where you want
to start recording.
To record programmed tracks
1. After step 5, program the track you want (perform steps 2~6 on
page 17).
2. Press [a REC/STOP] to start recording.
: One side is recorded, then recording stops auto-
matically.
: Both sides (front side reverse side) are
recorded, then recording stops automatically.
" in step 3, the direction will
" when recording starts.
23
RQT4708