Panasonic UF-E1 User Manual page 82

Programming Your Apparatus
TAM SETTING
No. Parameter
01 REMOTE
PASSWORD
02 ICM TRANSFER
03 ICM RECORDING
TIME
04 IN/OUT REMOTE
SET
05 CALL SCREENING
(See note1) (See note2)
NOTE
82
Selection
( - - - - )
ON / OFF
30, 60, 90,
(sec.)
ON / OFF
ON / OFF
1. The contents of Fax Parameter may differ depending on each country's regulation or specifi-
cation.
2. Factory setting may differ depending on each country's regulation or specification.
Set a 4-digit password for Remote Control
operation.
Select whether or not the apparatus calls the pre-
programmed location after an incoming voice
message is recorded in the built-in TAM.
180 Set the recording time for each incoming message.
Select whether or not the apparatus accepts the IN/
OUT mode to be changed using the Remote
Control operation.
Select whether or not you can monitor the incoming
call through the speaker while it is being recorded
and answer it if you wish by simply lifting up the
handset.
Comments Page
57
55
43
57
-----