Buick 2009 Enclave Owner's Manual page 83

vehicle will be discouraged because
of the high number of electrical
key codes.
If the engine does not start and the
security light on the instrument panel
comes on when trying to start the
vehicle, there may be a problem with
your theft-deterrent system. Turn the
ignition off and try again.
If the engine still does not start, and
the key appears to be undamaged,
try another ignition key and check the
fuses. See Fuses and Circuit
Breakers on page 5-88 for additional
information. If the engine still does
not start with the other key, the
vehicle needs service. If the vehicle
does start, the first key may be faulty.
See your dealer/retailer who can
®
service the PASS-Key
new key made. In an emergency,
contact Roadside Assistance. See
Roadside Assistance Program on
page 7-6.
It is possible for the PASS-Key
decoder to learn the transponder
value of a new or replacement key.
Up to 10 keys may be programmed
to the vehicle. The following
procedure is for programming
additional keys only. If all the
currently programmed keys are lost
or do not operate, you must see
your dealer/retailer or a locksmith
who can service PASS-Key
have keys made and programmed
to the system.
See your dealer/retailer or a
locksmith who can service
PASS-Key
blank that is cut exactly as the
ignition key that operates the
system.
III+ to have a
®
III+
®
III+ to
®
III+ to get a new key
Features and Controls
To program the new additional key:
1. Verify that the new key has a
1
stamped on it.
2. Insert the already programmed
key in the ignition and start the
engine. If the engine does not
start, see your dealer/retailer for
service.
3. After the engine has started, turn
the key to LOCK/OFF, and
remove the key.
4. Insert the key to be programmed
and turn it to the ON/RUN
position within five seconds of
the original key being turned
to the LOCK/OFF position.
The security light turns off once
the key has been programmed.
5. Repeat Steps 1 through 4
if additional keys are to be
programmed.
2-19