License Plate Lamp; Replacement Bulbs - Buick 2009 Enclave Owner's Manual

3. Remove the three hex nuts
holding the taillamp assembly in
place.
4. Pull out the taillamp assembly.
5. Turn the bulb socket
counterclockwise and pull it
straight out to remove it.
6. Replace the old bulb with a
new one.
7. Reverse steps 3 through 5 to
reinstall the taillamp assembly.
When reinstalling the taillamp
assembly, the plastic pin on the
taillamp assembly must line
up and be inserted correctly into
the opening.

License Plate Lamp

To replace one of these bulbs:
1. Remove the two screws holding
each of the license plate lamps
to the liftgate trim.
2. Turn and pull the license plate
lamp forward through the lift
gate trim opening.
3. Turn the bulb socket
counterclockwise and pull the
bulb straight out of the socket.
Service and Appearance Care
4. Install the new bulb.
5. Reverse steps 1 – 3 to reinstall
the license plate lamp.

Replacement Bulbs

Exterior Lamp
License Plate Lamp
Rear Sidemarker
Lamp
Rear Turn Signal
and Taillamps
For replacement bulbs not listed
here, contact your dealer/retailer.
5-35
Bulb
Number
194
194
7443
(W21/5W)