Buick 2009 Enclave Owner's Manual page 222

3-104 Instrument Panel
4. Continue entering digits until the
number to be dialed is complete.
After the whole number has
been entered, say "Dial".
The system responds with "OK,
Dialing" and dials the number.
•
If an unwanted number
is recognized by the system,
say "Clear" at any time to
clear the last number.
•
To hear all of the numbers
recognized by the system, say
"Verify" at any time and the
system will repeat them.
Using the Call Command
b g
1. Press and hold
two seconds. The system
responds with "Ready" followed
by a tone.
2. Say "Call". The system responds
with "Call using <phone name>.
Please say the name tag"
followed by a tone.
3. Say the name tag of the person
to call.
•
If the system clearly
recognizes the name tag it
responds with "OK, calling,
<name tag>" and dials
the number.
•
If the system is unsure it
recognizes the right name tag,
it confirms the name tag
followed by a tone. If the
name tag is correct, say "Yes".
The system responds with
"OK, calling, <name tag>" and
dials the number. If the name
tag is not correct, say "No".
The system will ask for the
for
name tag to be re-entered.
Once connected, the person called
will be heard through the audio
speakers.
Using the Re-dial Command
b g
1. Press and hold
two seconds. The system
responds with "Ready"
followed by a tone.
2. After the tone, say "Re-dial".
The system responds with
"Re-dial using <phone name>"
and dials the last number called
from the connected Bluetooth
phone.
Once connected, the person called
will be heard through the audio
speakers.
Receiving a Call
When an incoming call is received,
the audio system mutes and a
ring tone is heard in the vehicle.
b g
•
Press and begin speaking
to answer the call.
c x
•
Press to ignore a call.
for