Page 1
INSTALLATION INSTRUCTIONS FOR PART 99-3300 APPLICATIONS MULTI KIT see models list inside) 99-3300 KIT FEATURES • DIN Mount Radio Provisiion • Shaft Mount Radio Provisiion KIT COMPONENTS A) Radio Housing • Spacer TOOLS REQUIRED: Small Flat Blade Screwdriver/ Panel Removal Tool •...
Remove (1) Phillips head screw from above the instrument cluster. 99-3300 DASH DISASSEMBL Y Unclip and remove instrument cluster trim panel. Remove (2) 9/32” hex head screws securing radio. Unplug and remove radio.
(Figure A) Remove (2) 9/32” hex head screws securing radio. Unplug and remove radio. (Figure A) Cut and remove the rear support from the back of radio cavity. (Figure B) Continue to kit assembly. 99-3300 DASH DISASSEMBL Y Dash cavity...
Remove (2) 9/32” hex head screws from above instrument cluster. Engage parking brake and place gear selector in “D1”. 99-3300 DASH DISASSEMBL Y Unclip and remove instrument cluster trim panel. Remove (1) 9/32” hex head screw from the left edge of dash trim panel.
Unclip and remove the trim panel at each of dash and remove (1) Phillips head screw from behind panel. 99-3300 DASH DISASSEMBL Y Remove dash pad. Remove (3) Phillips head screws from top edge of instrument cluster/radio trim panel. Unclip and remove dash trim panel.
(4) screws from hinge to remove door. Open ashtray and remove (1) screw securing ashtray. 99-3300 DASH DISASSEMBL Y Remove ashtray and remove (1) screw from ashtray cavity. Unclip and remove small grill to the left of the ignition switch.
Remove (2) 9/32” hex head screws securing radio. Unplug and remove radio. Cut and remove the rear support from the back of radio cavity. (Figure A) Continue to kit assembly. 99-3300 DASH DISASSEMBL Y Dash cavity...
Chevrolet Malibu 1997-2000 isconnect the negative battery ter- minal to prevent an accidental short circuit. Unclip and remove the radio trim panel. Remove (2) 9/32” hex head screws securing radio. Unplug and remove radio. Continue to kit assembly. 99-3300 DASH DISASSEMBL Y...
Remove ashtray and remove (1) Phillips head screw from ashtray cavity. Remove (1) Phillips head screw from cigarette lighter cavity. 99-3300 DASH DISASSEMBL Y Unclip and remove the radio trim panel. Remove (2) 9/32” hex head screws securing radio. Unplug and remove radio.
DIN cage fror vehicles with shallow radio cavities if necessary. (Figure D) Slide the aftermarket radio into the cage until it snaps into place. (Figure C) Continue to final assembly. 99-3300 KIT ASSEMBL Y...
99-3300 KIT ASSEMBL Y SHAFT MOUNT RADIO PROVISION Note: Refer also to the instructions included with the aftermarket radio. Slide the aftermarket radio into the radio housing from the back and secure using shaft nuts supplied with the radio. (Figure A)
*NOTE: When a Black wire is not present, ground radio to vehicle chassis. All colors may not be present on all leads due to manufacturer’s specifications. 99-3300 FINAL ASSEMBL Y (A) Strip wire ends back 1/2" B) Twist ends together...