To Vary The Speed Setting - Dodge CHARGER 2015 Owner's Manual

NOTE:
• If your vehicle stays at standstill for longer than two
seconds, then the system will cancel and the brake
force will be ramped-out. The driver will have to apply
the brakes to keep the vehicle at a standstill.
• ACC cannot be resumed if there is a stationary vehicle
in-front of your vehicle in close proximity.
WARNING!
The Resume function should only be used if traffic
and road conditions permit. Resuming a set speed
that is too high or too low for prevailing traffic and
road conditions could cause the vehicle to accelerate
or decelerate too sharply for safe operation. Failure to
follow these warnings can result in a collision and
death or serious personal injury.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 179

To Vary The Speed Setting

To Increase Speed
While ACC is set, you can increase the set speed by
pushing the SET + button.
The drivers preferred units can be selected through the
instrument panel settings if equipped. Refer to "Under-
standing Your Instrument Panel" for more information.
The speed increment shown is dependant on the chosen
speed unit of U.S. (mph) or Metric (km/h):
U.S. Speed (mph)
• Pushing the SET + button once will result in a 1 mph
increase in set speed. Each subsequent tap of the
button results in an increase of 1 mph.
• If the button is continually pushed, the set speed will
continue to increase in 5 mph increments until the
button is released. The increase in set speed is reflected
in the DID.
3