Maintenance; Troubleshooting - Flymo sabrecut xt Operating Instructions Manual

Disposal:
(in accordance with
RL 2012/19/EU)
Disposal of
batteries:

7. Maintenance

w
Cleaning the Hedge Trimmer:
w

8. Troubleshooting

w
Problem
Hedge trimmer does not start
8
5871192-01_9672988-01.indd 8
The product must not be added to normal household waste.
It must be disposed of in line with local environmental regulations.
The NiMH battery contains NiMH cells that should not be
discarded with normal household waste at the end of their life.
1. Discharge NiMH batteries completely.
NiMH
2. Dispose of NiMH batteries properly.
DANGER! Risk of physical injury!
Cutting injuries can be caused if the hedge trimmer
does switch on unintentionally.
v B efore maintenance, remove the battery
e
(see 4. Initial Operation) and slide the protective
cover
ATTENTION ! Damage to the hedge trimmer!
v N ever clean the hedge trimmer under running water
or with a water jet (in particular a high pressure
water jet).
1. Clean the hedge trimmer with a damp cloth.
e
2. Clean the blade
a low-viscosity oil. Avoid contact of the oil with the plastic parts
and wear gloves.
DANGER! Risk of physical injury!
Cutting injuries can be caused if the hedge trimmer
does switch on unintentionally.
v R emove the battery before troubleshooting
e
(see 4. Initial Operation) and slide the protective
cover
Possible Cause
Battery is flat.
Battery not pushed onto the
handle properly.
Blade soiled (e. g. by resin).
Blade blocked.
over the cutter blade
w
with a brush, if required, and lubricate with
e
over the cutter blade
w
Remedy
v Charge battery
(see 4. Initial Operation).
v Push battery onto the
handle and make sure that
the locking buttons snaps
in correctly.
v Clean blade
(see 7. Maintenance).
v Remove obstacle.
.
e
.
e
12.06.14 10:08