Flymo Sabre Cut Original Instructions Manual
  1. Manuals
  2. Brands
  3. Flymo Manuals
  4. Trimmer
  5. Sabre Cut
  6. Original instructions manual

Flymo Sabre Cut Original Instructions Manual

Hide thumbs Also See for Sabre Cut:

Advertisement

Table of Contents

See also: User Manual , Original Instruction Manual
®
Sabre Cut
Original Instructions

Advertisement

Table of Contents
loading

Related Manuals for Flymo Sabre Cut

Summary of Contents for Flymo Sabre Cut

  • Page 1 ® Sabre Cut Original Instructions...

  • Page 2: Carton Contents

    Carton Contents Hedgetrimmer head storage holder screws x 2 blade cover instruction manual IMPORTANT ! Please check the contents of the carton are correct BEFORE assembling your new product. IF ANY PARTS ARE MISSING CONTACT:- Husqvarna UK Ltd. Customer Service Department direct Telephone : 0844 844 4558 UK 1800 882 350 ROI...
  • Page 3 Safety If not used properly this product can be dangerous! This product can cause serious injury to the opera- tor and others, the warnings and safety instructions must be followed to ensure reasonable safety and efficiency in using this product. The operator is responsible for following the warning and safety instruc- tions in this manual and on the product.

  • Page 4: Starting And Stopping

    Assembly Instructions Attatching the Hedgetrimmer to the Sabre Handle 1. Push the Hedgetrimmer head onto the Sabre Handle until you hear a click. (A1) 2. Push the Hedgetrimmer head further onto the Sabre Handle until it reaches the mark shown in Fig A2. 3.

  • Page 5: How To Use

    How to Use Cutting Positions 1. To change cutting position, press the button on the hedgetrimmer head (G1) and move to the position required. • Your Product has seven different cutting posi- tions (H), to enable high top cutting (J), side cutting etc (K).

  • Page 6: Caring For Your Hedgetrimmer

    Caring for your Hedgetrimmer Cleaning (L) 1. Using a soft brush - remove debris from all air intakes and cutting blade. 2. Wipe over surface of your hedgetrimmer with a dry cloth. • IMPORTANT Never use water for cleaning your hed- getrimmer.

  • Page 7: Environmental Information

    Fault Finding Hints Cutting blade stops under load Poor cut quality 1. Cut at a slower pace. 1. Ensure the product is being used correctly (see 2. If cutting blade still stops under load? How to Use) Disconnect from the Power Pack and consult 2.

  • Page 8: Service Recommendations

    Our policy of continuous improvement means that the specification of products may be altered from time to time without prior notice. Copyright © 2011 Flymo S.A. All rights reserved. Flymo® and other product and feature names are registered or unregistered trademarks of Flymo S.A.

This manual is also suitable for:

Sabre cut htc24a

Table of Contents