Putting Into Storage - Flymo sabrecut xt Operating Instructions Manual

Tilting the motor unit:
-60°
-45°
-30°
-15°
0°
15°
30°
45°
60°
75°
Extending the telescopic
pipe:
2
Starting the Hedge Trimmer:
w
r

6. Putting into Storage

Storage / Overwintering:
w
5871192-01_9672988-01.indd 7
For trimming at high and low level, the motor unit
at an angle of 75° to – 60 in 15° increments.
1. Remove the battery from the handle (see 4. Initial Operation).
2. Keep both orange buttons
3. Tilt motor unit
1 0
4. Release both orange buttons
engage.
5. Put the battery on the handle (see 4. Initial Operation).
For cutting at high and low heights, the telescopic pipe
continuously extended by up to 50 cm.
1. Remove the battery from the handle (see 4. Initial Operation).
2. Loosen the orange nut
q
require length, and tighten the orange nut
3. Put the battery on the handle (see 4. Initial Operation).
DANGER! Risk of physical injury!
If the Hedge Trimmer does not switch off
automatically, there is a risk of lacerations.
v N ever override the safety devices (e.g. by strapping
down the starting lock-out or the start button).
Switching on the Hedge Trimmer:
1. Remove the protective cover
e
2. Put the battery on the handle (see 4. Initial Operation).
3. Push the starting lock-out
button . The Hedge Trimmer will start.
t
4. Release the starting lock-out
Switching the Hedge Trimmer off :
1. Release the start button
t
2. Remove the battery from the handle (see 4. Initial Operation).
3. Slide the protective cover
Store out of the reach of children.
1. Remove and charge battery (see 4. Initial Operation).
2. Clean the hedge trimmer (see 7. Maintenance) and slide the
protective cover
e
3. Store the hedge trimmer in a dry, frost free place.
pressed.
0
in the required direction.
1
and allow motor unit
0
, extend the telescopic pipe
q
from blade
w
forwards and press the start
r
.
r
.
t
over the cutter blade
w
over the cutter blade
w
can be tilted
1
to
1
can be
2
to the
2
again.
q
.
e
.
e
.
e
7
12.06.14 10:08