Table 5-1 Configuration Menu Selections; Table 5-2 Audio Mode Selections - Garmin GTX 330 Installation Manual

The FUNC key steps to the next configuration page, after which the START/STOP key reverses until
stopping at the JUMP TO menu page.
SELECTION
DIAGNOSTICS
DISPLAY/AUDIO
I/O CONFIG
ACFT CONFIG
5.2.2 Audio Mode Pages
VOICE and VOLUME
Select desired VOICE. The choice of OFF is not available for
traffic (TIS) audio. Make sure the volume level is sufficient
for the aircraft environment involved.
MESSAGE
Message is used as a test function only. Message 0 is a continuous tone. Message 1 is a short tone and 2
through 5 are voice messages. Choose each selection to listen to the message.
SELECTION
VOICE (MALE/FEMALE) Sets the voice to male or female. Default is male voice.
VOLUME
MESSAGE (0-9)
ALTITUDE MONITOR
COUNT DOWN TIMER
PAGE CHANGE
GTX 330/330D Installation Manual
Page 5-6

Table 5-1 Configuration Menu Selections

Jumps to Gray Code Input page.
Jumps to Audio Volume page.
Jumps to ARINC 429 INPUT #1 page.
Jumps to Operation Configuration #1 page.

Table 5-2 Audio Mode Selections

Volume is adjusted from 0 (default) to maximum with the 8 or 9 key.
Selected audio tones and messages:
0 = Toggles a continuous tone on and off.
1 = Attention Tone, precedes voice messages to attract the pilot's
attention.
2 = "Leaving Altitude," when altitude monitor is active and the altitude
deviation is exceeded.
3 = "Traffic," when a TIS traffic alert is received (similar to a "Traffic
Advisory" in TCAS terms).
4 = "Timer Expired," when the countdown timer expires.
5 = "Traffic Not Available," when TIS service is not available or out of
range of an operating TIS Mode S site.
6 through 9 are not used at this time.
Off, tone or message
Off, tone or message
Enables/Disables Altitude Monitor sub page when altitude deviation is
exceeded.
DESCRIPTION
AUDIO MODE (First) Page
AUDIO MODE (Second) Page
DESCRIPTION
190-00207-02
Rev. U