3.2 Garmin Available Installation Materials
Refer to the tables below for a list of available Garmin standard kit items.
Unit
GTX 335
Unit
GTX 335 standard mount with
GPS
Unit
GTX 3X5 standard mount
Unit
GTX 335
GTX 335
3.3 Installation Materials Not Supplied
NOTE
The GTX series models are used with standard aviation accessories. Refer to the Acceptable
Hardware appendix for permitted installation hardware that can be necessary but not
supplied. Refer to AC 43.13-1B, Chapter 11, sections 5 through 7 for wire selection and
sizing information.
These items are necessary for installation, but are not supplied:
Insulated stranded wire (MIL-W-22759/16 or equivalent)
Shielded wire (MIL-C-27500 cable that uses M22759/18 wire (TG) or ETFE jacket (14), or
equivalent)
Coaxial cable
Aircraft hardware for installation, which includes screws, nuts/nutplates, washers, and rivets (Refer
to the Acceptable Hardware appendix)
Circuit breaker
Tie wraps or lacing cord
Ring terminals
Shield terminators (MS83519/2-X or equivalent)
Silicone fusion tape, A-A-59163 (MIL-I-46852C), or equivalent
USB A-to-B cable (for interface between a laptop computer and the GTX 335)
190-00734-17
Rev. 1
Table 3-1 GTX 335 Connector Kit Options
Connector Kit
Table 3-2 GTX 335 Backplate Assembly Options
Backplate assembly
Table 3-3 GTS 335 Mount Rack Options
Install Rack
Table 3-4 GTX 335 Configuration Module
Configuration Module
Garmin altitude encoder with
configuration module
Item
Item
Item
Item
GTX 335 w/GPS Installation Guidance
P/N
011-02977-00
P/N
011-02976-01
P/N
115-01771-01
P/N
011-00979-03
011-03080-00
Page 3-3