Figure D-10 Dual Txp To Gtn 6Xx/7Xx Interconect Wiring Diagram, Encoding Altitude Connections (Sheet 2 - Garmin GTX 330 Installation Manual

APPENDIX D INTERCONNECT DRAWINGS
GARMIN GARMIN
GTX 330 #1 GTX 330 #1
J3301 P3301 J3301 P3301
23 23
22 22
51 51
11 11
2
4
5
7
9
10 10
8
3
6
ALTITUDE COMMON (GROUND) ALTITUDE COMMON (GROUND) 50 50
62 62
GARMIN GARMIN
GTX 330 #2 GTX 330 #2
J3301 P3301 J3301 P3301
11 11
2
4
5
7
9
10 10
8
3
6
62 62
ALTITUDE COMMON (GROUND) ALTITUDE COMMON (GROUND)
50 50
23 23
22 22
51 51
190-00207-02
Revision U
GARMIN GARMIN
GTN 6XX/7XX GTN 6XX/7XX
P1001 J1001 P1001 J1001
S
S
Figure D-10 Dual TXP to GTN 6XX/7XX Interconect Wiring Diagram, Encoding Altitude Connections (Sheet 2 of 2)
NOTES: NOTES:
1. ALL WIRES 24 AWG OR LARGER UNLESS OTHERWISE NOTED. 1. ALL WIRES 24 AWG OR LARGER UNLESS OTHERWISE NOTED.
2. THE GTX 330 CONTAINS INTERNAL ALTITUDE CODE LINE ISOLATION DIODES. 2. THE GTX 330 CONTAINS INTERNAL ALTITUDE CODE LINE ISOLATION DIODES.
EXISTING INSTALLATIONS WITH DIODES INSTALLED IN THE WIRE HARNESS MAY EXISTING INSTALLATIONS WITH DIODES INSTALLED IN THE WIRE HARNESS MAY
BE USED "AS IS" WITHOUT REMOVING THE DIODES. BE USED "AS IS" WITHOUT REMOVING THE DIODES.
3. FOR ENCODER POWER INPUT USE DIODES OF AT LEAST 3 AMP, 50 VOLTS 3. FOR ENCODER POWER INPUT USE DIODES OF AT LEAST 3 AMP, 50 VOLTS
REVERSE RATING. REVERSE RATING.
4. 4. IF THE GTN IS TO CONTROL THE GTX 330 UNITS, THE GTX 330 UNITS IF THE GTN IS TO CONTROL THE GTX 330 UNITS, THE GTX 330 UNITS
MUST USE SOFTWARE VERSION 6.11 OR HIGHER. MUST USE SOFTWARE VERSION 6.11 OR HIGHER.
5. ANY AVAILABLE GTN 6XX/7XX RS-232 PORT MAY BE USED. 5. ANY AVAILABLE GTN 6XX/7XX RS-232 PORT MAY BE USED.
GARMIN SHIELD BLOCK GROUND GARMIN SHIELD BLOCK GROUND
AIRCRAFT GROUND AIRCRAFT GROUND S
(REFER TO 190-00313-09) (REFER TO 190-00313-09)
GTX 330/330D Installation Manual
Page D-14