Antenna Cable Connectors; Electrical Connections - Garmin GTX 330 Installation Manual

3. INSTALLATION PROCEDURE
3.1 ANTENNA INSTALLATION
3.1.1 Antenna Installation
Install the antenna according to the antenna manufacturer's instructions and FAA AC 43.13-2A.

3.1.2 Antenna Cable Connectors

The antenna cable requires a BNC connector at the antenna and a male BNC "Blindmate" connector
(P/N 330-00053-01, supplied with GTX 330 backplate assembly, 011-00582-00/01 at the transponder. Follow BNC
connector manufacturer instructions for assembly of the BNC connector.
3.2

ELECTRICAL CONNECTIONS

All electrical connections, except for the antenna, are made through a single, 62 pin D-subminiature connector.
Figure 2-1 defines the electrical characteristics of all input and output signals and identifies the cable requirements
for each signal. Required connector and associated hardware are supplied in the connector kit (P/N 011-00583-00).
See figures 4-1 and 4-2 for interconnect wiring diagrams.
Check wiring connections for errors before inserting the GTX 330 into the rack.
Incorrect wiring could cause internal component damage.
1. Insertion/extraction tools from ITT Cannon are all plastic; others are plastic with metal tip.
Non-GARMIN part numbers shown are not maintained by GARMIN and consequently are subject to
2.
change without notice.
3. All wires must be passed through the backshell before being assembled to connector.
GTX 330 Installation Manual
190-00207-02
CAUTION
Pin Contact Part Numbers
Wire Gauge
GARMIN P/N
Military P/N
Recommended Crimp Tools
Wire Gauge
Hand Crimping
Tool
Military P/N M22520/2-01
Positronic 9507
ITT Cannon 995-0001-584
AMP 601966-1
Daniels AFM8
Astro 615717
62 pin connector (P3301)
22-28 AWG
336-00021-00
M39029/58-360
20-24 AWG
Positioner Insertion/
Extraction Tool
M22520/2-08 M81969/1-02
9502-5 M81969/1-02
995-0001-604 980-2000-426
601966-5 91067-2
K13-1 M24308/1-02
615724 M81969/1-02
NOTES
Page 3-1
Rev. 1