Charging Time, Recordable Time And Remaining Battery Capacity Indication; Inserting/Removing Sd Cards (Sold Separately) - Panasonic SDR-S15 Operating Instructions Manual

2
Charging time, recordable time and
Setup
Remaining battery capacity indication
Charging time and recordable time
Times are given for a temperature of 25 ˚C and humidity of 60 %. The charging
time shown in the table are approximations. In high or low temperatures,
charging requires more time.
● Supplied battery VW-VBJ10 (3.6 V, 940 mAh (minimum))
Charging time
Maximum continuously
recordable time
Recordable time
Approx. 1 h 15 min
● Actual recordable time includes recording and stopping, turning the unit ON/
OFF, zooming and other operations.
● Recordable time varies according to conditions of use. For example, the
recordable time shortens when the [POWER LCD] setting is on while recording.
● The recordable time shortens in some environments (i.e., low temperatures,
etc.), therefore it is recommended to charge a spare battery.
Remaining battery capacity indication
The battery indication changes, as the remaining battery power decreases.
High
It has been found that counterfeit battery packs which look very similar to the genuine
product are available to purchase in some markets. Some of these battery packs are
not adequately protected to meet the requirements of appropriate safety standards.
These battery packs may lead to fire or explosion. Please be advised that we are not
liable for any accident or failure occurring as a result of use of a counterfeit battery
pack. To ensure that safe products are used we would recommend that a genuine
Panasonic battery pack is used.
16
LSQT1438
Approx. 2 h 15 min
Actual recordable time
Approx. 40 min
Low
Flashing (Charge battery.)
3
Inserting/Removing SD
Setup
cards
(sold separately)
SD cards are sold separately.
Preparations: Set the mode dial to [OFF].
(Check that the status indicator is out.)
Inserting or removing an SD card while the unit is turned
on may damage the unit and destroy data on the card.
Open the card/battery
1
door.
Open the door by sliding the card/
battery door lever to the "OPEN"
position.
Insert/Remove the SD
2
card.
• To insert:
Face the label upwards and slide
the card in straight until hearing it
catch.
• To remove:
Press the centre of the SD card and
pull the card out straight.
Close the card/battery
3
door.
• Close the card/battery door and
slide the card/battery door lever to
the "LOCK" position.
• If the door does not close
completely, remove the SD card,
check its orientation and reinsert it
into the slot.
● While the card access lamp is lit, reading, recording, playback, deletion
or other processing is being executed. Performing the following
operations while the lamp is lit may damage the SD card and its content
and the unit may not function properly.
• Turning off the unit
• Removing battery or AC adaptor
• Opening card/battery door and removing SD card
• Rotating the mode dial
• Shaking or impacting the unit
• Disconnecting the USB cable
● The access lamp is supposed to light up while rotating the dial to select
a mode. In this case, there is no problem.
Place label upwards.
Card access lamp
17
LSQT1438