ZyXEL Communications ARMOR Z1 NBG6816 User Manual page 13

Table 1 Front Panel LEDs (continued)
LED COLOR
Internet White
Off
2.4G WLAN/WPS White
Off
Amber
Off
5G WLAN/WPS White
Off
Amber
Off
Figure 2 Rear Panel
Chapter 1 Introduction
STATUS DESCRIPTION
On The ARMOR Z1 has an IP connection but no traffic.
Your device has a WAN IP address (either static or assigned by a
DHCP server), PPP negotiation was successfully completed (if
used) and the connection is up.
Blinking The ARMOR Z1 is sending or receiving IP traffic.
The ARMOR Z1 does not have an IP connection.
On The ARMOR Z1 is ready and the 2.4GHz wireless LAN is on, but
is not sending/receiving data through the wireless LAN.
Blinking The ARMOR Z1 is sending/receiving data through the wireless
LAN.
The wireless LAN is not ready or has failed.
On WPS is enabled. The ARMOR Z1 is in the process of firmware
upgrading, configuration restoring, or resetting.
Blinking The ARMOR Z1 is negotiating a WPS connection with a wireless
client.
WPS is disabled.
On The ARMOR Z1 is ready and the 5GHz wireless LAN is on, but is
not sending/receiving data through the wireless LAN.
Blinking The ARMOR Z1 is sending/receiving data through the wireless
LAN.
The wireless LAN is not ready or has failed.
On WPS is enabled. The ARMOR Z1 is in the process of firmware
upgrading, configuration restoring, or resetting.
Blinking The ARMOR Z1 is negotiating a WPS connection with a wireless
client.
WPS is disabled.
LAN 1-4
ARMOR Z1 User's Guide
13
WAN