Securing The Occupant; Wheelchair-Anchored Belts - Invacare FDX User Manual

A copy of SAE J2249 Wheelchair Tie-down and Occupant
Restraint Systems (WTORS) for use in Motor Vehicles can
be obtained from: SAE International, 400 Commonwealth
Drive, Warrendale, PA 15096-0001, (877) 606-7232 or
(724) 776-4970.
Attach WTORS to the tie-down brackets in accordance with the
manufacturer's instructions and SAE J2249.

6.7 Securing the Occupant

6.7.1 Wheelchair-Anchored Belts

WARNING!
– The pelvic belt that is provided by Invacare has been
tested for use in a motor vehicle on this wheelchair
only. Do not replace the pelvic belt with a different
style pelvic belt.
1163181-F~00
The wheelchair has been provided with a pelvic belt which meets the
requirements of ANSI/RESNA WC/19.
The pelvic belt provided by Invacare has been designed to
accommodate use on either side of the vehicle. If necessary, follow
the instructions below to reverse the orientation of the pelvic belt to
accommodate the vehicle-anchored upper torso belt.
Install the pelvic belt pin A into slotB in the pelvic belt bracket
1.
C. Pull upwards until it snaps into place.
Both ends of the pelvic belt D have a pin which is used
to secure the vehicle-anchored upper torso belt.
2. Repeat step 1 for the opposite pelvic belt bracket.
3. Install the vehicle-anchored upper torso belt onto the pin
Elocated at either end of the pelvic belt.
TransportReadyOption(TRRO)
55