Connection And Recognition - Panasonic HDC-HS100P Operating Instructions Manual

2
Setup
After the software applications are installed, this unit must be connected to the PC and be correctly
recognized by the PC.
≥ Remove the supplied CD-ROM from your PC.
A USB cable (supplied)
1
Connect this unit to the AC
adaptor.
2
Turn on the unit.
≥ This function is available in all modes.
3
Connect this unit to a PC.
The USB function selection screen will appear.
≥ Insert the USB connectors as far as they will go.
≥ Do not use any other USB connection cables
except the supplied one. (Operation is not
guaranteed with any other USB cables.)
4
Select [PC CONNECT] and press
the cursor button.
≥ This unit is automatically detected by the PC.
≥ [AVCHD CONNECT] is for future expansion
menu.
≥ When the unit is connected to a PC, the
operation mode cannot be changed and its
power cannot be turned off.
Disconnect the USB cable, before turning
this unit off.

Connection and recognition

≥ Do not disconnect the USB cable or the AC
adaptor while the card access lamp is on or
card access icon (
screen. Doing so may damage the data.
≥ Do not disconnect the USB cable or the AC
adaptor while the HDD access lamp is on or
HDD access icon (
screen. Doing so may damage the data.
∫ If the driver has not been
recognized properly
Use the following methods to enable it to be
recognized.
Method 1:
Turn off the unit and your PC once and try
verifying again.
Method 2:
Remove the SD card and try verifying again.
Method 3:
Try connecting the unit to another USB port on
your PC.
∫ To disconnect USB cable safely
1 Double click the
tray displayed on the PC.
≥ Depending on your PC's settings, this icon
may not be displayed.
2 Select [USB Mass Storage Device] and
click [Stop].
3 Verify [MATSHITA HDC-HS100/HDD USB
Device] or [MATSHITA HDC-HS100/SD
USB Device] is selected and click [OK].
) appears on the unit
) appears on the unit
( ) icon in task
119
VQT1T93