Oki OKIPAGE 8p Maintenance Manual page 21

(3) Pulse motor (Main)
This pulse motor of 48 steps/rotation is two-phase excited by the signal from the main control
board; it performs feeding control by switching normal rotation to reverse rotation or vice
versa and turning on/off the electromagnetic clutch. The relationship between the main
motor, electromagnetic clutch, resist gear, drum gear, hopping roller is shown in the table
below and on the subsequent pages.
Main Motor
Normal rotation
Reverse rotation
(4) LED head
The shift and latch registers receive image data from the main control board for each dot line.
4,992 LEDs are driven to radiate the image drum.
(5) Heat Assy
The heat Assy consists of a heater, a heat roller, a thermistor, and a thermostat.
The power supply unit supplies AC voltage to the heater according to the HEATON signal
from the main control board to heat the heat roller. The main control board monitors the heat
roller temperature via the thermistor and keeps the temperature constant by turning on/off
the heater AC voltage supply.
If the heat roller temperature rises abnormally, the thermostat of the heater voltage supply
circuit functions to forcibly suspend the AC voltage supply.
Electromagnetic Clutch Hopping Roller
OFF
ON
OFF
2 - 9
Regist Gear
Non-rotation Non-rotation
Rotation Rotation
Non-rotation Rotation
Drum Gear Operation
Rotation Warm-up
Rotation
Hopping
Rotation Prinitng