External Display - Panasonic CF-73 Series Reference Manual

External Display

1
Power off your computer.
(⇒Operating Instructions "Starting Up/Shutting Down")
Do not shut down using the standby or hibernation function.
2
Connect the external display.
Connect the external display to the external display port (A) on your computer.
3
Turn on the external display, then turn on your computer.
After Windows starts up, the screen is displayed on both the internal LCD and the
external display.
It is possible to change the setting to display only on the external display or on both
the internal LCD and the external display with Fn+F3.
4
Set your external display.
Windows XP
Select [Start] - [Control Panel] - [Appearance and Themes] - [Display] - [Settings] -
Advanced] - [Monitor] and make the monitor settings. When a monitor that does not
conform to the Plug & Play standards is connected, select [Properties] - [Driver] -
[Update Driver] in [Monitor] to update the driver.
Windows 2000
Select [Start] - [Settings] - [Control Panel] - [Display] - [Settings] - [Advanced] -
[Monitor] and make the monitor settings. When a monitor that does not conform to
the Plug & Play standards is connected, select [Properties] - [Driver] - [Update
Driver] in [Monitor] to update the driver.
NOTE
The display destination after resuming from hibernation mode or after restarting may
differ from the display destination before entering hibernation mode or before
restarting.
When changing the display destination after Windows has started, do not press any
keys or press the power switch until the display destination has changed completely.
When the display destination of the screen is switched using Fn+F3 after the
[Command Prompt] screen is set to "Full Screen", the display destination returns to
the destination before switching if an "Exit" is input and the [Command Prompt] screen
is closed. This can also happen if the "Full Screen" is canceled via an Alt+Enter
command. Press Fn+F3 again.
When the external display is used alone, set the number of colors, resolution, or
refresh rate to suit the external display. These settings are separate from when the
internal LCD is used alone or with an external display simultaneously.
56