Panasonic CF-73 Series Reference Manual page 97

Dealing with Problems (Advanced)
Connecting Peripherals
The cursor does not move from mouse
operations
A PC Card does not work
USB floppy disk drives do not work as
a boot drive
You do not know the available RAM
module
Cannot tell whether the RAM module
has been correctly installed
The RAM module has not been
recognized
Check your mouse connection.
A driver which is compatible with the connected mouse must be installed.
If the device does not operate when the driver is installed: In the Setup Utility,
set [Touch Pad] and [Touchscreen](only for models with touchscreen) to
[Disable].
Make sure the card is properly inserted.
Confirm that the card conforms to the PC Card Standard.
Note that after a driver (PC Card driver on other) is installed, the computer must
be restarted.
Check that the proper port settings have been made.
Read the operating instructions for the PC Card. Or, you may need to call the
manufacturer of the PC Card.
Try removing/reinserting the PC Card by following the proper procedure.
( page 51)
Confirm that a driver for your operating system has been installed.
Only the Panasonic CF-VFDU03 USB floppy disk drive (optional) can be used.
Do not connect the floppy disk drive to the USB connector of the port replicator
for this computer.
Make sure [Legacy USB Support] is enable in the Setup Utility.
After powering off the computer, connect the USB floppy disk drive and restart
the computer.
page 53
You can check whether the RAM module is recognized using [Information]
menu in the Setup Utility. If the RAM module is not recognized, turn the
computer off and reinsert the RAM module.
Make sure the RAM module has been properly inserted.
Use the RAM module that supports the recommended specifications (
53).
97
page