External Display - Panasonic CF-29 Series Reference Manual

External Display

1
Power off your computer.
(⇒Operating Instructions "Starting Up/Shutting Down")
Do not shut down using the standby or hibernation function.
2
Connect the external display.
Connect the external display to the external display port (A) on your computer.
3
Turn on the external display, then turn on your computer.
After Windows starts up, the screen is displayed on the display destination set in
the following menu.
Windows XP
[Start] - [Control Panel] - [Other Control Panel Options] - [Intel(R) Extreme
Graphics] - [Devices]
Windows 2000
[Start] - [Settings] - [Control Panel] - [Intel(R) Extreme Graphics] - [Devices]
It is possible to change the setting to display only on the external display or on both
the internal LCD and the external display with Fn+F3.
4
Set your external display.
Windows XP
Select [Start] - [Control Panel] - [Other Control Panel Options] - [Intel(R) Extreme
Graphics] - [Devices] - [Monitor] and make the settings.
Windows 2000
Select [Start] - [Settings] - [Control Panel] - [Intel(R) Extreme Graphics] - [Devices] -
[Monitor] and make the settings.
NOTE
The display destination after resuming from hibernation mode or after restarting may
differ from the display destination before entering hibernation mode or before
restarting.
When changing the display destination after Windows has started, do not press any
keys or slide the power switch until the display destination has changed completely.
Fn+F3 does not work when [Command Prompt] screen is set to "Full Screen".
When the external display is used alone, set the number of colors, resolution, or
refresh rate to suit the external display. These settings are separate from when the
internal LCD is used alone or with an external display simultaneously.
68